
OpenToonz's Fill > Frame Range interpolates the click position between chosen drawings; it does not track a moving region semantically. When the target bends or changes direction, add intermediate Shift-click positions or split the task into shorter ranges, then inspect every affected drawing.
Key Takeaways
- A straight interpolation path can miss a curved motion.
- Intermediate clicks define another segment of the filling path.
- A completed range operation still needs drawing-by-drawing review.
Set up the documented range mode
The OpenToonz 1.7.1 painting manual specifies Fill Tool, Type: Normal, Mode: Areas and Frame Range for this workflow. It warns that linearly interpolated click points can cause painting mistakes as the target moves.
Save a level copy before a range operation. Choose the intended palette style and examine the target area at its first, middle and last drawings. If the area disappears, splits or becomes occluded, do not assume one uninterrupted fill range remains meaningful.
Add anchors where the target changes course
Click inside the desired area on the first frame. For a simple path, select the last frame and click inside the same corresponding area. For a more complex path, select an intermediate frame and Shift-click its target area; add further intermediate positions as needed, then use an ordinary click on the last frame to finish.
Keep each click inside the intended region rather than on an antialiased boundary. The intermediate point constrains a linear segment; it is not a guarantee of correct filling in every drawing between the anchors.
Proposed example: a sleeve moving around a face
Imagine a character's sleeve moves left, then arcs upward around the face. A direct start-to-end interpolation can cross the face midway even though both endpoint clicks are correct. On a copy, add an intermediate sleeve position near the bend, or fill the two sections separately.
This is a proposed inspection exercise. It reports no measured success rate and does not claim that additional anchors resolve every changing topology.
Review all affected drawings before saving over a master
Step through the filled range, including frames between anchors. Check that the sleeve is colored, the face is not, and any occluded interval follows the intended design. Compare the level with the preserved copy if a wrong region was filled.
Accept only after the entire range passes. If the region changes shape too much, use shorter ranges or individual fills rather than accumulating anchors without review. The tool can reduce repeated clicks, but the artist still decides which region each drawing should contain.
Related tasks
- Use Krita Onion Skins to Diagnose AI Pose Jitter
- How to Insert Time Across Visible Layers in Krita’s Timeline
- Should You Drag a Krita Palette Swatch to the Layer Stack or the Canvas?
Sources and scope
- OpenToonz1.7.1 official documentation: Frame Range fill interpolates positions; Shift-click intermediate frames supplies another segment anchor.
Based on the OpenToonz 1.7.1 published manual, including saved official full-body capture read on 2026-10-23. Later releases are not assumed equivalent. Examples and acceptance checks are proposed editorial procedures, not executed software tests. No measured query frequency or AI citation frequency.
Prepared by Imagild Editorial, the company editorial team responsible for these guides. AI assisted research and drafting. This is documentation-based guidance with proposed examples, not a claim of hands-on testing or an independent product review. Report a correction.
Cover: Paparazzi Ratzfatzzi / Pexels, Pexels License. This is an illustrative source photograph, not an application screenshot or a generated test result.