
In the Resolve 20 workflow documented by Blackmagic, Replace aligns the source and timeline playheads and ignores source In and Out points. Put both playheads on corresponding action frames, then constrain the destination deliberately. Do not expect a marked source range to control Replace like an ordinary range-based edit.
Key Takeaways
- Treat the two playheads as the alignment reference.
- Check timeline boundaries and destination tracks before replacing.
- Review the whole replacement, including audio and adjacent cuts.
Choose an identifiable matching moment
For a portrait film, you might replace a shot with an alternative take of a person looking toward the camera. Identify a precise moment in each take, such as the beginning of the head turn. A broad description like “near the smile” gives a weaker alignment reference.
Put the timeline playhead on the moment you want to preserve in the edit. Position the source playhead on the corresponding moment in the alternative. These are editorial choices; the software cannot determine which expression best serves your story.
Set the replacement's scope
Blackmagic's Resolve 20 Beginner's Guide explains that Replace ignores source In and Out points, while timeline In and Out points can limit the affected interval. It also demonstrates selecting the intended video destination and disabling audio editing for a picture-only replacement.
For a picture-only replacement on Video 2, set the video destination to Video 2 using its track destination control and click the A1 destination control off so the audio is not replaced. Check which controls are active before applying the command. An alternative camera take may include audio you do not want to substitute for an approved narration track.
Click Replace Clip in the timeline toolbar or press F11. If the timeline In and Out marks deliberately limit a repair, check those bounds before pressing it; the marked source In and Out do not determine this operation. This guide describes the Resolve 20 training workflow; verify differences if your interface is newer.
Review both sides of the result
After replacement, inspect the entry, the aligned moment and the exit. Another take can deliver the same gesture more slowly or frame the subject differently. A correctly aligned moment does not guarantee that the surrounding action fits the existing shot length.
In a hypothetical replacement, the new smile reaches the chosen frame accurately, but the hand movement continues beyond the existing cut. Decide whether to trim, choose another source moment or reject the take. Avoid silently changing the film's timing merely because Replace completed.
Accept the change in the full film
Play the nearby sequence with sound. Confirm that the intended audio remains and that the replacement does not reveal a jump in continuity. If you use a transition, inspect the available source handles.
Export a short comparison and check preview against output. Record which take replaced which shot so a later review can distinguish an alignment correction from a broader editorial change.
Source: Blackmagic's Resolve 20 Beginner's Guide, printed pages 89–97.
Related tasks
- Why Won’t a Transition Fit Between Two Video Clips?
- Captions look correct in preview but move in the export: isolate a small render test
Sources and scope
- The Beginner's Guide to DaVinci Resolve 20, Replace Edit: Printed pages89-97: Replace aligns playheads, ignores source In/Out, accepts timeline limits, and uses video/audio destination controls.
Prepared by Imagild Editorial, the company editorial team responsible for these guides. AI assisted research and drafting. This is documentation-based guidance, not a claim of hands-on testing or independent review. Report a correction.
Cover: Pignatta / Pixabay, Content License. The city photograph is an illustrative source asset; it does not show this application or a test result.