
Reconstruct Mesh returning to 100% after the Mesh panel’s Apply command is documented behavior in Affinity Photo 2. It does not, by itself, prove that your reduced warp was discarded. Judge the image before and after applying the change rather than treating the slider number as a permanent record of the earlier choice.
Key Takeaways
- Reconstruct Mesh sets overall warp strength.
- The Mesh panel’s Apply step establishes a new strength baseline.
- Grid opacity controls visibility of the guide, not distortion strength.
Separate the image from the grid
The official Mesh panel reference distinguishes Reconstruct Mesh from Opacity. The latter changes how visible the overlay is. A fainter grid therefore cannot demonstrate that a heavy deformation has become gentler.
Before editing, choose a contour in the image that can serve as your reference. For a proposed product-photo exercise, use the straight edge of an unbranded package beside a curved ribbon. The ribbon is the intended target; the package edge gives you a stable visual landmark.
Reduce and commit one controlled warp
- Preserve a separate working copy before experimenting.
- Make a modest Liquify change in the intended region.
- Reduce Reconstruct Mesh until the image, rather than just the mesh overlay, shows the desired amount.
- Note a recognizable before-and-after landmark or retain a comparison image for this decision.
- Use the Mesh panel’s Apply command and compare the contour again.
The reference explicitly documents that this command applies the current warp and returns Reconstruct Mesh to 100%. Do not confuse that panel command with an instruction to repeat the original deformation. A second push of the brush would introduce another change and make the comparison ambiguous.
Check the result instead of repeating the percentage
For the ribbon example, inspect the same bend at the same zoom. If its reduced curvature remains, the visible outcome supports accepting the change even though the control now reads 100%. Re-entering the previous percentage automatically would be a new intervention, not proof that the first one succeeded.
If the result is unclear, return to your preserved comparison and repeat with one small, obvious deformation. Avoid diagnosing the problem from several overlapping brush passes whose individual effects are difficult to recognize.
Keep recovery separate from strength
Reset Mesh is documented as removing current effects and creating a new mesh. Treat it as a deliberate reset, not a harmless way to make the number familiar again. For recoverable experiments, keep the checkpoint until you have inspected the image and saved the intended working version. This procedure proposes a verification method; it does not report a tested pixel match.
Related tasks
- How Should I Plan Liquify Points, Lines, and Curves in darktable 5.6?
- Undo a Smart Object’s Distortion Without Reverting Its Contents
- Why Can I Edit My Saved Layers but Not Undo Yesterday’s Steps?
Sources and scope
- Why Does Reconstruct Mesh Return to 100% in Photo 2? — official feature reference: Reconstruct Mesh controls overall warp strength; zero removes current effect; Mesh-panel Apply applies the warp and resets the setting to 100%; grid opacity is a display control.
Official Photo 2 help directly retrieved through browser research. Proposed exercises and acceptance checks are original editorial recommendations, not firsthand application tests. All 1930 live, 187 reserved and currently authored records checked for matching controls and task overlap; independent review remains required.
Prepared by Imagild Editorial, the company editorial team responsible for these guides. AI assisted research and drafting. This is documentation-based guidance with proposed examples, not a claim of hands-on testing or an independent product review. Report a correction.
Cover: William Liu / Pexels, Pexels License. This is an illustrative source photograph, not an application screenshot or a generated test result.