
A REAPER plug-in output remap does not necessarily silence the channels left unmapped. The pin connector's I/O menu includes Pass thru unmapped output channels and Zero unmapped output channel. With passthrough enabled, those channels can retain the unprocessed signal even when the effect's processed output goes elsewhere.
Key Takeaways
- Read the unmapped-channel policy as well as the visible pin connections.
- Dry passthrough can be intentional when processed audio occupies another channel pair.
- Clearing a path without checking downstream routing can remove wanted sound instead.
Draw the intended channel arrangement
For a hypothetical narration treatment, suppose dry audio should remain on channels 1/2 while a reverb's processed output occupies 3/4. That is different from wanting only the reverb output and no original voice on 1/2.
Write those paths before editing the matrix. A pre/post-fader send controls where a feed follows a level control; it does not answer what this plug-in does with unmapped channels.
Inspect pins and the output policy together
Open the effect's pin connector. Confirm the track channel count and plug-in channel configuration, then inspect the input/output intersections. The REAPER 7.81 guide gives an example where track channels 1/2 enter a two-channel effect and the processed result leaves on 3/4.
In the same interface's I/O menu, inspect the choice between passing through or zeroing unmapped outputs. The manual's example deliberately enables passthrough so the dry signal remains available on 1/2.
The absence of an effect-output pin on 1/2 is therefore not sufficient evidence that those channels are silent.
Choose the policy for the intended result
Keep passthrough when the downstream arrangement genuinely needs the original signal on otherwise unmapped channels. If the intended path requires those outputs to contain no passed-through audio, evaluate the documented zero-unmapped choice in a project copy.
Do not clear every pin as a shortcut. That can interrupt the effect input, the wet output or another needed channel. Change the policy and mappings only after identifying their roles.
Follow the channels beyond this effect
Inspect which channels the next processor, track routing and final output actually consume. A dry signal deliberately preserved on 1/2 can remain audible if those channels still reach the mix, even though the reverb uses 3/4 correctly.
Audition each intended path and the recombined result. Check for unintended doubling or a voice that weakens when combined, using the separate mono-cancellation guide when appropriate. Acceptance is the planned channel flow and approved sound; this documentation-based procedure does not claim a completed routing test.
Related tasks
- Why Does Reverb Stay Loud When I Lower the Voice Fader in Premiere?
- Why Does My Voice Disappear When the Film Plays on a Phone Speaker?
Sources and scope
- REAPER User Guide 7.81: Pin connector supports track/plugin channel counts and I/O mappings. I/O menu Pass thru unmapped output channels versus Zero unmapped output channel determines whether unprocessed audio passes through unmapped outputs. Official example maps wet1/2 to3/4 while dry passes1/2.
Based on the official REAPER 7.81 user guide downloaded and read on October 23, 2026. The proposed listening and configuration checks have not been performed; no measured result is claimed.
Prepared by Imagild Editorial, the company editorial team responsible for these guides. AI assisted research and drafting. This is documentation-based guidance with proposed examples, not a claim of hands-on testing or an independent product review. Report a correction.
Cover: Rumeyda Tutak / Pexels, Pexels License. This is an illustrative source photograph, not an application screenshot or a generated test result.