
Changing a timeline's displayed ruler is not the documented way to send synchronization timecode from REAPER. Use Insert > SMPTE LTC/MTC Timecode Generator to create a generator item, then inspect its Source properties. Following another device's clock is a separate transport-synchronization task.
Key Takeaways
- Decide which application or device supplies the clock.
- A generator item, displayed time label and synchronization input are different resources.
- Creating the item alone does not verify reception by another device.
Choose the clock direction
For a hypothetical picture-and-sound session, decide whether REAPER should supply a synchronization signal or wait for an external source. Write down the intended receiver or sender and the supported protocol before adding anything to the project.
A review timecode note identifies an editorial position; it is not a clock connection. Similarly, drop-frame labels describe a numbering convention rather than proof that an external device is synchronized.
Create the generator on an intentional track
Select the track intended for the synchronization resource. The REAPER 7.81 manual's section 23.7 documents Insert > SMPTE LTC/MTC Timecode Generator, which creates a media item on that track.
Identify the item clearly so it is not mistaken for ordinary program content. Keep the source project and current routing state available before configuring a device connection.
This procedure has not created an item or connected equipment. It does not assume that a device accepts whichever protocol appears first in a menu.
Configure the source and receiving route
Right-click the generator item and choose Source properties. The manual documents selecting LTC or MTC and configuring the required parameters there. Use the actual receiving device's documentation for compatibility and connection requirements.
Do not infer a complete hardware or MIDI routing recipe from the generator command alone. Confirm the chosen protocol, destination and required timing convention with that receiver. A visible item demonstrates project structure, not successful external reception.
Keep following timecode separate
Section 23.6 instead begins external synchronization from the transport Play button's context dialog and an input choice. It explicitly directs users to the external device's documentation. Configuring a generator does not automatically configure that receiving role.
For acceptance, perform a controlled start/stop and position comparison through the intended equipment setup, retaining the observed result and unresolved limits. This is a proposed verification, not an executed synchronization test. Do not label the system synchronized solely because its ruler displays familiar timecode.
Related tasks
- Which Timecode Should I Send When Requesting a Premiere Shot Revision?
- Does Drop-Frame Timecode Mean My Video Is Missing Frames?
Sources and scope
- REAPER User Guide 7.81: Sections23.6–23.7 pages456–457: Insert > SMPTE LTC/MTC Timecode Generator inserts generator mediaitem on currenttrack; right-click Source properties chooses LTC or MTC and parameters; following externaldevice uses right-click Play synchronization dialog/input; externaldevice docs required.
Documentation-based guidance from the verified official REAPER 7.81 manual, read on October 23, 2026. Proposed diagnostic projects, creative sound examples and external-device checks have not been executed; no recovery, latency, compatibility or listening result is claimed.
Prepared by Imagild Editorial, the company editorial team responsible for these guides. AI assisted research and drafting. This is documentation-based guidance with proposed examples, not a claim of hands-on testing or an independent product review. Report a correction.
Cover: William Liu / Pexels, Pexels License. This is an illustrative source photograph, not an application screenshot or a generated test result.