
ReaComp's normal stereo mode bases compression on the active channels together. An event on one side can therefore influence the processing applied across that linked group. If the channels contain independent sources, inspect detector linkage before changing thresholds to compensate for the interaction.
Key Takeaways
- Normal stereo, multi-mono and multi-stereo use different analysis groupings.
- Independent analysis does not mean different parameter settings per channel.
- The documented sidechain workflow requires normal stereo mode.
Identify the relationship between the channels
Are the channels a stereo image, two independent microphones, or several stereo pairs? The answer determines what should share a compression decision. Listen to the actual source; a two-channel file alone does not establish a stereo scene.
For the source-identification task, see the two-microphone guide. This article addresses what the compressor analyzes after the channels have been identified.
Choose analysis grouping rather than changing the source map
The REAPER 7.81 manual, section 16.9, documents the following distinction:
| ReaComp mode | Analysis scope |
|---|---|
| Normal stereo | Active channels together |
| Multi-mono | Each channel independently |
| Multi-stereo | Each stereo pair independently |
The multi modes use the same settings across their independently analyzed channels or pairs. They are available through the ReaComp I/O button's right-click menu and are mutually exclusive.
Preserve the sidechain requirement
The manual says normal stereo mode is mandatory for its compressor-sidechaining workflow. Do not select multi-mono as a blanket cure for interaction when the intended effect depends on a separate detector route.
Record the actual channel layout and routing before modifying the mode. This guide does not supply an unverified multichannel pin configuration or claim that choosing a mode repairs an incorrectly mapped source.
Test an asymmetric event at matched settings
In a saved comparison, find a passage where one source has a strong event and the other remains comparatively quiet. Keep the compressor parameters fixed while evaluating the analysis grouping. Listen for the effect on both sides or pairs, not just the triggering event.
The stereo-normalization guide covers a different operation that can change channel relationships. Acceptance here is the intended detector coupling with an acceptable output balance. No listening test, gain-reduction measurement or successful channel-mode change is claimed.
Related tasks
- How Do I Edit Two Microphones Recorded on One Stereo Clip Separately in Premiere?
- Why Did Loudness Normalization Change My Audacity Stereo Balance?
Sources and scope
- REAPER User Guide 7.81: Section 16.9 Channel Modes: default stereo summed active channels; I/O context multi-mono independent each channel same settings; multi-stereo independent each pair; stereo mandatory sidechain.
Based on the official REAPER 7.81 user guide downloaded on October 23, 2026. Examples and acceptance checks are proposed procedures; no application execution, listening test or measured result is claimed.
Prepared by Imagild Editorial, the company editorial team responsible for these guides. AI assisted research and drafting. This is documentation-based guidance with proposed examples, not a claim of hands-on testing or an independent product review. Report a correction.
Cover: William Liu / Pexels, Pexels License. This is an illustrative source photograph, not an application screenshot or a generated test result.