
Use REAPER's transport Global Auto control when the requirement is a temporary automation override across the project. No global override removes that policy and returns each track to its previous automation mode. It also turns envelope bypass off, so ending an override deserves a deliberate check.
Key Takeaways
- A global override can mask different underlying track modes.
- Envelope bypass and automation-mode selection are separate choices.
- Removing the override restores previous modes and disables bypass.
Record the project state before a global audition
A short-film mix may legitimately contain tracks in different modes. Note the relevant tracks and their modes before changing the project-wide policy. Save an approved version if the audition could lead to later edits.
The REAPER 7.81 manual, section 18.10, documents the transport control's scope. Do not assume that the mode currently governing playback is the same as every track's underlying saved choice.
Choose the operation the review actually needs
Right-click Global Auto on the transport bar. The documented menu can bypass all envelopes, select one automation mode for all tracks, or toggle display of active envelopes.
Those operations answer different questions. Hiding an envelope is not bypassing its processing. Bypassing envelopes is not equivalent to selecting a writing mode. State the purpose of the audition before choosing among them.
The Read-mode fader guide explains why a stored envelope can move a control. A project-wide override adds another policy layer that must be understood before diagnosing that movement.
Remove the overlay instead of rebuilding track modes
When the temporary audition is finished, choose No global override. The official manual explicitly says each track returns to its previous mode and bypass is turned off.
Do not manually set every track to one common mode simply because that matches the final global audition. That would fail to restore the original heterogeneous arrangement. Also inspect any writing-capable modes that become effective again before resuming playback.
Verify mode restoration and the audible route
Compare the tracks against the recorded starting state and listen through the relevant section hands off. If an effect balance remains unexpected, inspect routing separately; the pre/post-fader reverb guide addresses that different ownership question.
Acceptance is restoration of the intended per-track policies with no unnoticed bypass state. This documentation-based procedure does not claim an executed restoration, altered mix or measured playback result.
Related tasks
- Why Does My Premiere Audio Fader Snap Back During Playback?
- Why Does Reverb Stay Loud When I Lower the Voice Fader in Premiere?
Sources and scope
- REAPER User Guide 7.81: Section 18.10: Global Auto right-click menu, bypass all envelopes, single mode all tracks, display active envelopes; No global override returns previous modes and disables bypass.
Based on the official REAPER 7.81 user guide downloaded on October 23, 2026. Examples and acceptance checks are proposed procedures; no application execution, listening test or measured result is claimed.
Prepared by Imagild Editorial, the company editorial team responsible for these guides. AI assisted research and drafting. This is documentation-based guidance with proposed examples, not a claim of hands-on testing or an independent product review. Report a correction.
Cover: William Liu / Pexels, Pexels License. This is an illustrative source photograph, not an application screenshot or a generated test result.