
OBS recommends placing a Limiter last in the source's filter chain. If gain-changing processing follows it, the limiter is no longer the final control in that chain. Also distinguish a source's limited output from any later mixing or external stage: a limiter on one source does not certify every subsequent output.
Key Takeaways
- Inspect filter order before lowering the threshold repeatedly.
- The limiter's Threshold applies at that filter.
- Verify the saved mix, including its loudest expected passage.
Locate the stage that is overloading
The OBS Limiter reference describes a fast, high-ratio compressor and recommends it as the last filter in the chain. Its Threshold defines the maximum output level for that processed signal.
Record where the problem appears: in the original microphone, after a source filter, in the combined recording, or only during playback. Do not conclude that a distorted source was repaired merely because the downstream meter is now lower. Reducing level cannot establish that earlier damage is absent.
Inspect order and gain deliberately
- Preserve the existing filter setup and identify the affected source.
- List its filters in their current order.
- Place the Limiter after gain-changing source processing, as the guide recommends.
- Check its Threshold and Release against the intended delivery.
- Record a representative loud passage and inspect the actual file.
A useful test includes the loud voice or sound that triggered the concern. A quiet sentence that never approaches the threshold cannot demonstrate the limiter's behavior at the relevant moment.
If the same sound is captured twice, use the duplicate application-audio routing check. Lowering a limiter is a poor substitute for identifying unintended parallel paths.
Review the combined sound separately
Consider a proposed event introduction containing narration, a music accent and an applause effect. Each source may appear acceptable alone, while their simultaneous playback creates a different combined requirement. A source-level setting should not be described as approval of that full mix.
Review the overlap and the return to normal speech. Record whether the result is clean, whether the transient sounds excessively flattened, and whether the voice remains understandable. The documented Release controls how quickly gain reduction stops after the signal falls below threshold; it is not an automatic guarantee of transparent sound.
Verify the delivery boundary
Open the saved recording using the intended listening route and review the relevant peak as well as ordinary narration. Preserve the source settings and the tested passage in the handoff notes.
Accept only the tested complete result. If distortion remains, identify whether it was already in the source or introduced later rather than asserting that the presence of a limiter proves protection. The procedure is a documentation-based diagnostic and does not report an executed overload test.
For delivery with dialogue and music, also check the combined mix headroom rather than treating a source limiter as proof that the final mix cannot clip.
Related tasks
- Why Does Adding OBS Application Audio Capture Make the Recording Echo?
- I requested 10 seconds in 16:9. How do I check the actual AI video file?
- How Do I Keep the Approved AI Image or Video from Getting Lost Among Revisions?
Sources and scope
- OBS Limiter Filter: OBS recommends Limiter as the last filter; its threshold is the maximum output level at that filter.
Documentation-based guidance. No account access, hands-on test, measured speed gain, search volume or AI citation rate is claimed.
Prepared by Imagild Editorial, the company editorial team responsible for these guides. AI assisted research and drafting. This is documentation-based guidance with proposed examples, not a claim of hands-on testing or an independent product review. Report a correction.
Cover: AI-generated conceptual editorial illustration; not a real application screenshot, observed output or before-and-after test.