
LosslessCut documents a special audio-only case in which a file's sync-sample table can make cut positions differ between keyframe modes. Diagnose that condition separately from a video keyframe boundary or a normal timestamp reset. A whole-file remux is a documented test for the relevant case, not a universal audio repair.
Key Takeaways
- Audio-only files can have indexing behavior that affects seeking and cuts.
- Compare the exported boundary in both relevant cut modes.
- Preserve the source while testing a remuxed intermediate.
Confirm that this is the documented audio-only case
Inspect the source's streams and container. Record the requested start, the audible output start and the selected keyframe mode.
The LosslessCut troubleshooting documentation describes an audio-only example in which one mode cuts early and the other late because only some audio packets are marked as sync samples.
Do not apply that explanation to every inaccurate cut. A file with a video stream has additional dependency-frame considerations, and a shifted timestamp can be a separate issue. Review the audio trim clock distinction when the numeric interpretation is uncertain.
Compare actual audible boundaries
Choose a short passage with a recognizable onset. Export the same requested range under the relevant modes to separate filenames.
Listen from before and after the intended event. Do not judge only by the duration label or a silent leading interval; the required question is whether the intended source sound begins where it should.
Record which mode was used for each output so later comparisons do not mix up the files.
Test the whole-file remux route
For the documented sync-table case, the official guide suggests exporting the whole file without cutting, then cutting that intermediate. Its purpose is to remove the troublesome table through remuxing.
Keep the original unchanged. Verify the intermediate's duration and audible content before using it as the next input.
If the remuxed file changes required metadata or fails playback, stop and inspect the compatibility problem rather than treating the intermediate as automatically repaired.
Accept the cut by listening and timing
Export the intended interval from the chosen input and check its first required sound and final required event. Compare the result with the source at recognizable points.
If the discrepancy remains, retain the source details and test observations for investigation. Another compatible editor may be appropriate where exact audio decisions cannot be expressed reliably through this stream-copy route.
Check sound tails at the ending as well as the start. A precise opening does not compensate for losing the final word or reverberation.
Related tasks
- Why Does an FFmpeg Audio Trim Not Start and End Where I Expected?
- Why Does My Film End Smoothly but Cut the Last Word or Reverb Tail?
Sources and scope
- LosslessCut Troubleshooting: audio only sync sample table cut modes
Based on the official LosslessCut project documentation, retrieved October 23, 2026. Master-branch instructions can change; the workflows and clearly marked expression examples are documentation-based and were not executed in the application.
Prepared by Imagild Editorial, the company editorial team responsible for these guides. AI assisted research and drafting. This is documentation-based guidance with proposed examples, not a claim of hands-on testing or an independent product review. Report a correction.
Cover: Pignatta / Pixabay, Pixabay Content License. This is an illustrative source photograph, not an application screenshot or a generated test result.