
Lightroom Classic's Auto-Stack By Capture Time operates on the folder or collection chosen as the source, even when only a few thumbnails are selected. Limit the source deliberately before treating the thumbnail selection as the operation's scope.
Check before stacking
- Which folder or collection is active?
- Which capture-time gaps should define a new group?
- Does the resulting grouping match the actual session?
Understand what the time slider means
Adobe's stacking guide documents source-wide auto-stacking and a time-gap threshold. Contiguous photographs close enough in capture time are grouped; a sufficiently large gap starts another stack.
That is a time rule, not an understanding of subjects or camera brackets. A rapid change from a portrait to a detail shot can remain one time-based group. Conversely, a long pause within one planned sequence can split it.
Start by deciding what a stack is meant to represent in your project. Do not use a convenient slider value as a substitute for that definition.
Isolate a reviewable group
For a hypothetical event, separate the intended review set from an entire day's folder by using an appropriate ordinary collection. Verify its membership before invoking the operation.
Choose Photo > Stacking > Auto-Stack By Capture Time, then adjust the gap for the actual capture pattern. The relevant question is where the new group begins, not whether a longer duration sounds more inclusive.
Review the first group, a boundary near a pause, and a location where the subject changed quickly. These checks are proposed review points, not a claim that an optimal interval has been measured.
Repair grouping without discarding frames
Expand the resulting stacks and inspect their members. If grouping is wrong, revise the organization using the supported stacking controls. Preserve the photographs while deciding how they should be grouped.
A stack's top image is a browsing representative, not proof that its other members are rejected or redundant. Keep culling and deletion as separate decisions.
Verify the scope after the operation
Compare the active source and stack membership with your intended set. If more images changed than expected, investigate the source-wide behavior before repeating the command with a different thumbnail selection.
Record the source and chosen gap alongside the review result. The task is complete when groups support the actual capture sequence and no collaborator must infer the operation's scope from which thumbnail happened to be highlighted.
Related tasks
- Why Did My Lightroom Batch Edit Affect Only One Photo in Each Stack?
- Why Do Photos Disappear from a Lightroom Smart Collection After I Rate Them?
Sources and scope
- Adobe: Group photos into stacks: Auto-Stack By Capture Time applies to all photos in selected folder/collection regardless of thumbnail selection; gap-based grouping and command path.
Prepared by Imagild Editorial, the company editorial team responsible for these guides. AI assisted research and drafting. This is documentation-based guidance, not a claim of hands-on testing or independent review. Report a correction.
Cover: Pignatta / Pixabay, Content License. The city photograph is an illustrative source asset; it does not show this application or a test result.