A Kdenlive scrolling title can stop before its timeline clip ends or be cut off while still moving. Check the title editor’s animation Duration separately from the timeline clip length: the first sets how long the movement takes, while the second sets how long the title clip exists on the timeline. Trimming the clip alone does not change the scroll speed.
Diagnose the mismatch and choose a field
Kdenlive’s official title-scrolling manual describes the built-in animation as linear movement between start and end viewports. Their positions determine the direction; Duration controls the movement speed.
- Select the title clip and open it in the title editor. In the Animation tab, note the
Durationand check where the start and end viewports sit relative to the text. - Separately record the clip’s length on the timeline. Don’t infer one value from the other; they are independent.
- Play through the ending and note whether the title reaches its intended endpoint and then holds, or whether the clip ends while the title is still moving.
- Decide what must stay fixed. To keep the current pace, change the timeline length to give the animation enough time. To keep the clip length fixed, change the title editor’s
Duration; a smaller value makes the scroll faster, and a larger value makes it slower. - Apply the change in the relevant place. After editing the title, click Update Title, then play the ending again.
Compare two hypothetical timing cases
The table uses hypothetical values, an upward scroll, and an end viewport positioned below the text so the intended final view has all the text out of frame. These are diagnostic examples, not software test results or a guarantee about a particular frame.
| Hypothetical case | Animation Duration | Timeline clip | Direction and end observation | Field to adjust |
|---|---|---|---|---|
| A | 8 seconds | 12 seconds | Upward; the scroll reaches its endpoint, then the final view holds for the remaining clip time. | Shorten the clip to 8 seconds to remove the extra hold without changing pace, or set Duration to 12 seconds if the clip must stay 12 seconds and slower motion is acceptable. |
| B | 12 seconds | 8 seconds | Upward; the clip ends before the title reaches its endpoint. | Extend the clip to 12 seconds to preserve pace, or set Duration to 8 seconds if the clip must stay 8 seconds and faster motion is acceptable. |
For acceptance, compare the last visible frame with the intended end viewport: all text meant to scroll out should be gone, or any intended final pose should be present. Also check the ending in playback, not just the timeline’s clip boundary.
Limits and what to check next
If the timing relationship looks right but the ending image is wrong, inspect the viewport positions and confirm that the end viewport covers the intended final composition. For an upward scroll that should leave the screen completely, the manual says to place the end rectangle below the text field. Then update the title and review the ending again; changing either duration cannot correct a misplaced endpoint.
The manual characterizes the built-in animation as rudimentary and linear. For motion more elaborate than a straight, steady scroll, it points to other effects rather than describing extra timing controls in this title animation. Treat that as a feature limit, not a reason to keep extending or shortening the clip until the movement looks different.
Three quick questions
- How can I check whether the endpoint is positioned correctly? For a complete upward exit, compare the end viewport with the text field and inspect the final image. The manual specifies placing that viewport below the text field.
- The scroll finishes, but some words remain visible. Should I change `Duration`? First check whether the end viewport is positioned to show the full intended exit; timing cannot move the endpoint.
- Can I deliberately leave a pause after the credits scroll? Yes. A clip that outlasts the animation can retain the final view; use that extra time only if the hold is part of the intended ending.
Sources and next step
This guide interprets public documentation and uses explicitly hypothetical acceptance examples, not application tests. Controls and availability can change; verify the cited manual against your installed version.
For work created in Imagild, carry the input requirements and acceptance checklist into the film workspace. The external software controls discussed above belong to their respective products.