With Facing Pages enabled, InDesign labels the horizontal margins Inside and Outside. Inside refers toward the binding relationship; Outside refers away from it. Inspect both left- and right-hand pages instead of treating Inside as a fixed physical left edge everywhere.
Separate a page's hand from a screen direction
In a conventional facing-page spread, the binding relationship switches sides between the two pages. A larger inside margin is intended to protect content near that relationship on both page hands, not to create the same absolute left margin throughout the document.
Adobe documents changing these settings through Layout > Margins And Columns on selected pages, spreads, or parent pages. The selected scope matters: a local page change is different from changing the parent that other pages inherit.
Verify the spread as a pair
- Preserve the layout and confirm whether Facing Pages is intended for this publication.
- Identify the target pages or parent and the actual binding-side requirement.
- Set Inside and Outside values in the supported margin controls.
- Review both page hands, important text clearance, and the final output geometry.
Margin guides are part of layout planning. They do not independently prove that a particular printer's binding allowance is adequate. Obtain the actual production requirement and inspect a suitable proof where the physical result matters.
Keep a margin scope card
| Item | What to identify |
|---|---|
| Publication setup | Facing or single pages |
| Page hand | Inside edge for that page |
| Setting scope | Selected page, spread or parent |
| Production requirement | Actual binding and safe-content allowance |
For an illustrated book using AI imagery, keep essential faces, labels, and text clear of the approved binding region rather than relying only on a pleasing full-spread screen preview.
Questions about margins
Is Inside always the left margin? Its relationship follows the facing-page binding side.
Will changing one page change every page? Inspect the selected scope and parent relationship.
Does this choose the printer's duplex flip setting? Duplex feed and flip behavior require a separate device-specific check.
Sources and next step
The examples and review checks are editorial guidance, not reported application tests. For a subsequent transformation, open the Imagild photo editor with the specific approved input or brief described above.
Related reading: Why Does InDesign Keep Reapplying Formatting to Certain Text Patterns?; Can I Add PDF Navigation Bookmarks Without a Visible Contents Page in InDesign?; Why Is the Back of My Double-Sided Photo Card Upside Down?.