
This happens because Final Cut Pro replaces existing keyframes in the destination parameter within the pasted keys' time range. Keys outside that interval remain. Before pasting, choose the exact parameter and start frame, then inspect both boundaries of the resulting animation.
Key Takeaways
- Pasting keys can replace part of an existing parameter animation.
- The playhead or skimmer determines where the pasted sequence begins.
- Review the join before and after the pasted interval.
Decide whether to merge or replace the motion
Suppose a photo-film shot already has an opening move and an ending hold. You want to insert a small animated adjustment in the middle. That is different from replacing the whole shot's animation.
Identify which parameter should change. Position, opacity and an effect's strength are separate targets. Copying the right keys does not help if you select the wrong destination graph.
Set the target and starting frame
Select the source clip and choose Clip > Show Video Animation, or press Control-V, to open its Video Animation editor. Apple documents copying keys in this editor or the Audio Animation editor. Select the source keys, copy them, select the destination clip and parameter, and position the playhead where the pasted keys should begin.
The guide says the playhead or skimmer must be over the selected clip. It also explains that some parameter types can only paste to compatible parameters. If nothing appears, inspect those conditions before repeating the paste in several places.
Keep an identifiable pre-paste version or use the project's normal reversible workflow. Avoid improvising over the only accepted animation.
Inspect the replacement interval
After pasting, look at the destination graph. The copied interval replaces keys already inside that interval; earlier and later keys remain. This explains why the result can contain a mixture of original and pasted motion.
Use an illustrative test with an opening hold, a middle move and an ending hold. Paste a shorter motion in the middle. Confirm which keys disappeared and which remained, then play through both joins. A sudden change can occur at the boundary even when every intended key exists.
Do not judge the result only at keyframe positions. The movement between them is part of the delivered animation.
Verify the final motion
Play the complete shot at its intended speed and inspect the frame before and after each join. Check the subject's position, framing and movement direction. If the result is wrong, revise the selected interval rather than repeatedly pasting over an increasingly unclear graph.
For a different issue involving a shorter destination, see pasted animation outside the target clip. For unwanted movement between equal positions, inspect interpolation-related boomerang motion.
Source: Apple's keyframe copy and paste guide.
Related tasks
- Pasted Animation Stops Early: Are Its Keyframes Outside the Shorter Clip?
- Why Does a Layer Move Away and Return Between Equal Position Keyframes?
Sources and scope
- Apple: Copy and paste keyframes in Final Cut Pro: Paste begins at playhead/skimmer, requires target parameter and clip overlap; destination keys within pasted interval are replaced, keys outside remain; some types require compatible parameters.
Prepared by Imagild Editorial, the company editorial team responsible for these guides. AI assisted research and drafting. This is documentation-based guidance, not a claim of hands-on testing or independent review. Report a correction.
Cover: Pignatta / Pixabay, Content License. The city photograph is an illustrative source asset; it does not show this application or a test result.