A cycle that advances during rehearsal can show a discontinuity when timeline playback or recording begins. Adobe's Cycle Layers documentation distinguishes Immediately from Synced to timeline, which does not advance through layers while stopped on a frame. Inspect the cycle's clock before renaming image files or changing the scene frame rate.
Determine which clock the performance needs
A decorative cycle may be allowed to run freely during live performance. A repeated review at a specific scene time needs a reproducible relationship to the timeline. State which requirement applies. “It looked right while stopped” is weak evidence when rehearsal time has been allowed to advance the displayed layer.
Choose a clearly distinguishable sequence of drawings for diagnosis, such as a fictional indicator with three numbered states. The numbers are review artwork, not a request to burn test labels into the final film. Preserve the approved unnumbered cycle for delivery and keep the diagnostic copy separate.
Inspect the cycle’s start reference
In the documented synchronized mode, the cycle is related to the original start of the puppet track. Moving the track later preserves the cycle's relationship to that track start; extending the in-point earlier has its own documented first-layer behavior. Record the actual track placement and start policy instead of assuming every loop begins at composition zero.
Do not move the puppet track and change the cycle option simultaneously. First observe the existing state, then alter one condition and repeat the same timing check. Otherwise a correct timing mode can be blamed for a change caused by a different in-point.
An original repeated-time review
For a hypothetical three-state indicator inside a puppet, select three scene times within its valid coverage. Stop at each time, allow a short rehearsal pause, then start playback or recording and return to the same times. No Character Animator test was executed for this example.
| Review point | First pass | Repeat after rehearsal | Decision |
|---|---|---|---|
| Early inside the item | Record visible state | Record again | Same timeline relationship? |
| Midpoint | Record visible state | Record again | Unexplained phase change? |
| Near the end | Record visible state | Record again | Intended loop boundary? |
Use the frame actually displayed, not a thumbnail cached from a previous position. If recorded playback is stable but live rehearsal differs, describe that difference accurately. It does not establish that the exported film jumps in the same way.
Confirm timing in the delivery, then remove diagnostics
After selecting the appropriate start behavior, record or render the required interval and reopen the actual result. Check the expected cycle phase against the approved timeline and any accompanying sound or cue. Review an intentional item shift as a new timing condition rather than assuming the earlier test still covers it.
Replace temporary numbered artwork with the approved visuals and repeat the short check. Keep the timing mode, puppet-track start and accepted interval in the handoff notes. For an Imagild animation concept, these notes can state the desired phase relationship, but they do not configure Adobe's cycle clock. Completion means reproducible playback where reproducibility is required, not simply a pleasing frame that appeared during an unrecorded rehearsal.