
Aseprite Replace Color combines a timeline scope with any active canvas selection. Selected limits the operation to selected timeline elements; All applies it across the sprite's cels. A canvas selection alone does not restrict which frames are affected when All remains selected.
Key Takeaways
- Timeline selection and canvas selection are separate restrictions.
- All can replace the selected canvas region in every cel.
- Tolerance and RGBA controls further determine what changes.
Record both dimensions of the selection
The Aseprite Replace Color documentation explains the bottom Selected/All control and its interaction with a selected canvas region. In All mode, that region applies across all sprite cels; in Selected mode, it applies to selected content in selected timeline elements.
Before changing a brand accent, list the frames and layer components that should change and those that must remain approved. A marching-ants region communicates position, not the entire temporal scope.
- Save an identifiable master before replacement.
- Select the intended timeline elements.
- Define the canvas region if the replacement must be spatially restricted.
- Open Edit > Replace Color or use Shift+R, and confirm Selected rather than All when appropriate.
- Inspect color choice, tolerance and RGBA components before applying the change.
The manual defines tolerance zero as exact-color replacement and larger values as including increasingly similar colors. Do not use a high tolerance simply to make an uncertain selection appear successful.
A hypothetical one-frame accent change
Suppose a badge's final frame needs a new ribbon color inside one small region. The editor selects that region but leaves All active. Earlier cels can then receive the same spatially limited replacement.
The useful fix is to restore the intended version and correct timeline scope before repeating the operation. Painting the old color back into every other frame obscures which cels were actually affected.
The batch-setting allowlist guide addresses which edits should travel across photographs. This problem instead concerns the intersection of a cel selection and a pixel-region selection within one animation.
Verify protected content after replacement
Inspect the target frame, neighboring frames and another cel with a similar color inside the selected region. Check components that were intended to remain unchanged, including alpha when relevant to the chosen RGBA state.
Accept when the intended pixels change in the intended cels and protected content remains intact. If too many colors change, revisit tolerance; if too many frames change, revisit Selected/All and the timeline selection. These are separate failure branches, so change one setting at a time and compare a separately identified candidate.
Related tasks
- Which Photo Edits Should I Copy to a Whole Set, and Which Should Stay Individual?
- How Do I Keep Photo-Based Pixel Art from Becoming Random Colored Noise?
- Why Does Loading an ACT Palette Recolor My Photoshop Indexed Image?
Sources and scope
- Aseprite Replace Color: Selected versus All timeline scope intersects with active canvas selection; tolerance and RGBA component controls.
Documentation-based guidance. Scenarios, worksheets and acceptance procedures are proposed or hypothetical; no hands-on test, benchmark, search-volume measurement or AI-citation ranking is claimed.
Prepared by Imagild Editorial, the company editorial team responsible for these guides. AI assisted research and drafting. This is documentation-based guidance with proposed examples, not a claim of hands-on testing or an independent product review. Report a correction.
Cover: AI-generated conceptual editorial illustration; not a real application screenshot, observed output or before-and-after test.