
Before sharing an Affinity Photo 2 macro, inspect its recorded operation list and uncheck steps that do not belong in the recipe. Stop recording, review operation settings and test the intended sequence on a disposable document before exporting an .afmacro file. A successful recording session is not the same as a clean reusable procedure.
Key Takeaways
- An accidental recorded operation can travel with the macro unless excluded.
- Review both the operation list and the settings inside each relevant step.
- A Library entry and a shared .afmacro file serve different handoff needs.
Define the intended transformation
The official Photo 2 macro guide describes sequential playback, excluding operations and changing recorded settings. Start with a short description of the useful recipe. That gives you something concrete against which to judge each recorded entry.
For a proposed proof-image treatment, the intended sequence might add one correction and a border. During recording, you may also have made a temporary adjustment to inspect the picture. If that operation remains enabled, the recipient receives your experiment as part of the recipe rather than only the treatment you meant to share.
Clean the operation list deliberately
- Stop recording before reviewing the sequence.
- Read the entries in execution order and compare them with the intended recipe.
- Uncheck unwanted operations rather than assuming they will be ignored.
- Open relevant operation settings to check values that are not obvious from the entry name.
- Play the cleaned macro on a separate test document and inspect the result.
The manual also allows certain parameters to be exposed using an eye control in the recorded action's settings. If you choose an interactive recipe, explain which value the recipient is expected to decide. Do not describe every recorded operation as supporting the same configurable parameters.
Share the procedure rather than only a screenshot
Save the approved macro to the Library if it should remain locally available, or use Export to create the .afmacro file for transfer. Include the intended application version, expected starting document and any steps the recipient should perform outside the macro.
A picture of the final result cannot tell another editor which recorded steps were enabled. Keep a concise operation note with the file, especially where the test uses a deliberately different source image.
Accept playback on a fresh starting point
For the proposed proof treatment, confirm that the desired correction and border appear and the temporary adjustment does not. Reopen or reimport the shared file through the appropriate workflow and repeat the recipient's expected entry point. This is a proposed verification plan, not a claim of a completed import test. If playback differs, inspect the saved operation list and source assumptions before adding compensating steps that make the recipe harder to understand.
Related tasks
- Why Does a Shared Photoshop Action Paint With a Different Brush?
- Reuse a Photoshop Curves Setting Without Replaying a Whole Action
- Which Photo Edits Should I Copy to a Whole Set, and Which Should Stay Individual?
Sources and scope
- Macros: Recorded operations run sequentially; uncheck unwanted operations, retrospectively change settings, expose supported parameters, export .afmacro or save Library.
Directly read official Photo 2 help. Original documentation-based synthesis and proposed checks, not firsthand application testing. Existing and reserved titles screened; near-neighbor decisions are identified explicitly.
Prepared by Imagild Editorial, the company editorial team responsible for these guides. AI assisted research and drafting. This is documentation-based guidance with proposed examples, not a claim of hands-on testing or an independent product review. Report a correction.
Cover: William Liu / Pexels, Pexels License. This is an illustrative source photograph, not an application screenshot or a generated test result.