
Check which Blend Ranges graph you changed. In Affinity Photo 2, Source Layer Ranges controls visibility according to tones in the selected layer. Underlying Composition Ranges lets tones in the composition below show through it. Similar-looking curves can therefore produce different results.
Key Takeaways
- Source and Underlying sample different parts of the layer relationship.
- Dark tones lie on the left of each graph; bright tones lie on the right.
- Test one graph at a time before refining the transition.
State which image should supply the visible detail
Affinity's Layer blend ranges reference describes the two graphs and their tonal direction. Select the layer whose blending you intend to control, then open its Blend Options.
Consider a proposed paper texture over a portrait. There are two different requests: remove the dark marks from the paper itself, or allow dark features in the portrait below to come through. Both can make the portrait more visible, but they depend on different tonal information.
Write the desired relationship in those terms before dragging nodes. Otherwise, a curve that looks promising on one face can fail on a second photograph for reasons the editor cannot explain.
Compare the two graphs independently
Save a copy and begin with one graph at its default state. Adjust the relevant portion of Source Layer Ranges while leaving Underlying Composition Ranges unchanged.
Moving Source nodes downward reduces the selected layer's visibility at the corresponding tones. Return that graph to its default before testing Underlying. Moving Underlying nodes downward makes the corresponding underlying tones more visible through the selected layer.
Keep the same images and layer placement throughout this comparison. Changing the portrait and the curve together would prevent a useful diagnosis.
| Intended tonal decision | Graph to inspect |
|---|---|
| Hide darker or brighter parts of the selected texture | Source Layer Ranges |
| Reveal darker or brighter information from below | Underlying Composition Ranges |
Recheck the relationship after a source change
A tonal blend is not a named-object selection. If the underlying portrait becomes lighter, an Underlying-based result may change because its input tones changed. If the texture changes, a Source-based result may change.
That behavior can be intentional. For a reusable treatment, note which graph provides the selection logic so the next editor can distinguish an expected response from a misplaced curve.
The Photoshop Blend If transition guide addresses edge softness in another control system. Here the first decision is which tonal source Affinity's graph should evaluate, before tuning the shape of that graph.
Accept a predictable blend
Inspect a dark, middle and bright region relevant to the design. Toggle the treatment and confirm which layer supplies the visible detail in each area. Then make a small reversible change to the chosen input and check whether the blend responds as expected.
Accept the result when the intended tonal relationship is clear and the important portrait features remain suitable. The comparison is proposed documentation-based guidance, not a measured claim about every image pair.
Related tasks
- Why Does Photoshop Blend If Create a Harsh Cutout Edge?
- How Do I Combine a Painted Mask and a Gradient Without Flattening Them in Affinity Photo 2?
- How to Revise a Krita Filter Mask’s Affected Area
Sources and scope
- Layer blend ranges: Official documentation for the controls and limits discussed above.
Official desktop documentation research; no hands-on testing, search-volume or citation-rate claims. Any example or diagnostic procedure is proposed editorial guidance.
Prepared by Imagild Editorial, the company editorial team responsible for these guides. AI assisted research and drafting. This is documentation-based guidance with proposed examples, not a claim of hands-on testing or an independent product review. Report a correction.
Cover: AI-generated conceptual editorial illustration; not a real application screenshot, observed output or before-and-after test.